Flat-bottomed Plain Track A small range of products for use with soldered track construction. The recommended rails are EMGS Code 83, Peco Code 82, and P4 Track Company Code 82

CC01T

Etch for 0.5mm 1 in 20 inclined spacers for plain track construction. To be used with cast pewter cosmetic half baseplates. 90 spacers + 3 spacers with wiring tags.
Note that this etch is included when purchasing my PAN11 castings.
£1.50   P&P £0.50

CC03T
Etch for construction of BR1 baseplates with
elastic spike bending jig. Will make a 60’
panel of track with sleeper centres of 700mm,
or 750mm.
The correct 1 in 20 rail inclination is built into
the design. Widely installed on main lines
during the BR steam period post 1950, and
subsequently cascaded down to secondary
and siding use in the post modernisation
period. P4, EM, and 00.
£2.50   P&P £0.50
CC03Tb
Bulk pack with 5 etched sheets
£11.00 P&P £1.00

CC04T
Etch for construction of BR2 baseplates with
Macbeth spike bending jig. Will make a 60’
panel of track with sleeper centres of 700mm,
or 750mm.
The correct 1 in 20 rail inclination is built into
the design. Widely installed on main lines
during the BR steam period post 1950, and
subsequently cascaded down to secondary
and siding use in the post modernisation
period. P4, EM, and 00.
£2.50   P&P £0.50
CC04Tb
Bulk pack with 5 etched sheets
£11.00 P&P £1.00

CC10T
Pair of fold-up stainless steel etched track gauges for rail with 1 in 20 inclination. Currently available for Code 83 flat-bottomed rail as supplied by the EMGS, and for Peco / P4 Track Co Code 82 rail. Available for P4, EM, or 00. 00 gauges are now available for either 32mm or 34mm length sleepers.
Note that the “Code No” relates to the height of the rail in
thousandths of an inch. The actual head and foot
characteristics vary between manufacturers, thus
necessitating different gauges.
£2.00 (Please state gauge and rail origin)    P&P £0.50

CC11T
Cosmetic Pewter castings of PAN11 (visually the same as PAN2 and PAN6) baseplates with Pandrol® PR clips. Sprues supplied for the outer and inner halves of the baseplates. For use with CC01T inclined spacers etch, which is included with the castings. 23 sprues of each half (equivalent 92 baseplates). Sufficient for 0.42m track with sleepers spacing at 700mm prototype specification
£9.50   P&P £1.00

CC31T
Copper-clad epoxy/fibreglass sleepers for plain track 34mm x 3.3mm x 1.6mm. P4/EM
Pack of 100 sleepers £6.00 P&P £1.00

CC32T
Copper-clad epoxy/fibreglass sleepers for plain track 32mm x 3.3mm x 1.6mm. 00
Pack of 100 sleepers £6.00 P&P £1.00